Six Technical Points on POE in Compressor and Refrigeration Oils
Classification: Industry News
Oct 23,2026

Rotary screw compressor: where POE earns its 8,000 hours
Whether a screw compressor survives 8,000 hours is often not about the compressor. It is about whether the refrigeration oil was selected correctly.
The short answer
POE (polyol ester) is the mainstream route for refrigeration oils and synthetic compressor oils because it solves both extremes at once: it can run continuously at about 200 °C and briefly above 300 °C (decomposition begins around 280 °C), while still flowing at about −60 °C.
1. Six key properties of POE
| Property | Behaviour | What it means for the equipment |
| Heat resistance | Approx. 200 °C continuous, 300 °C+ short term | No coking in screw machines with high discharge temperature |
| Low-temperature flow | Flowable at approx. −60 °C | Reliable low-temperature oil return in refrigeration circuits |
| Viscosity index | Generally 150+, some grades up to 220 | Stable viscosity across a wide temperature window |
| Anti-wear behaviour | Polar molecules adsorb on metal surfaces, high film strength | Lower start-up wear |
| Volatility | Low volatility; flash point approx. 280–300 °C, fire point approx. 320 °C | Low evaporation loss, safer at high temperature |
| Toxicity | Non-toxic; suitable for environmentally acceptable lubricants | Meets environmental requirements |
2. POE's special position in refrigeration circuits
POE shows good compatibility across HFC refrigerant systems and hydrocarbon refrigerant systems — which is why it became the mainstream refrigeration oil. MarkWide Research additionally notes that the EU F-Gas regulation phase-down is pushing compressor lubricant demand toward formulations compatible with low-GWP refrigerants — a structural tailwind for POE.
3. Three points that belong in your operating procedure
- Immiscible with mineral oil — a system previously run on mineral oil must have residual oil removed before switching to POE.
- Hygroscopic and hydrolytic — esters have moderate hydrolytic stability and absorb moisture readily; avoid open exposure. With water present and heat applied, they decompose.
- Seals and coatings — POE has a low aniline point (some polyol esters around 8 °C) and causes a degree of swelling in rubber seals and hoses, though less than diesters; blending in some PAO is a common mitigation.
4. What we supply
- Diester · Saturated Complex / Polyol Ester · Complex Ester
- Further reading: Refrigeration Lubricant Technical Note · How POE Is Synthesised
👉 Tell us your refrigerant type, discharge temperature and target oil-change interval. We will match the POE viscosity grade.
Contact us
Talk to the ICASON peroxide team
Tel: +86 16639328358 Whatsapp: +86 16639328358 Wechat: 166393238358 E-mail: icason001@icason.com
Related Blog